Hougen 12006 12,000 Series Annular Cutter Kit 5/8, 3/4, 7/8, 1, 1-1/8" 2-Inch Depth of Cut 3/4-Inch Weldon Shank For Magnetic Drills

Features:

• Two flats for cutter mounting System is rigid and offers up to 2x the tool life as compared to quick change or one touch tool mounting systems
• O.D. Margin Only a thin area of material touches the outside of the hole which provides for less friction and a better hole finish, I.D. Taper Relief area between slug and cutter to reduce HP and improve slug ejection
• Patented Hougen Edge Geometry Provides faster, smoother cuts, with less chatter
• Ground and Fully Fluted Provides better chip evacuation, requires less HP and offers better performance in deeper holes
• Hougen 12006 M2 HSS Diameters Included 2 5 8, 3 4, 7 8, 1, 1 1 8 , 2 Pilots and hex wrenches with plastic case , Made In USA
• TWO FLATS FOR CUTTER MOUNTING This system is very rigid and offers up to 2x the tool life as compared to quick change or one touch tool mounting systems. The Original Mag Drill Annular Cutter From Which All Others Are Measured.
• GROUNDED FULLY FLUTED Provides better chip evacuation, requires less HP and offers better performance in deeper holes.
• O.D. MARGINS Only a thin area of material touches the outside of the hole which provides for less friction and a better hole finish.
• PATENTED HOUGEN EDGE GEOMETRY Provides faster, smoother cuts, with less chatter. Each tooth has two or three angles.
• I.D. TAPER Relief area between slug and cutter. Reduces horsepower and improves slug ejection.